TDC and run through the valve order like any other solid cam ( #1 E I should be closed and sloppy rocker arms ) Quick search will give you the order, than rotate 180 degrees. I've used Mac Quick sticks for years ( Google them)
Set at .016 ( manufactures recommendation I'm assuming) little drag on the feeler gauge, that will get you fired up for break in, check again after the cam broken in ( follow procedure ,important) you will be fine.
The procedure listed in here for the 30-30 is great, same one we use on the race motor running a hydo roller,yep, it's profile requires a little slop in the valve train per the engine builder.
Your running nothing radical, modern profile, traditional procedure.