1
Originality / Re: 1967 L78 Window Sticker Analysis
« on: July 08, 2024, 07:00:49 AM »
That's very cool! It should be easy to fab a firewall flange to mate up to the air cleaner with a rubber connector.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Ball bearings on the input shaft are more tolerant to bell housing misalignment. Muncies use that type.
Factory bell housing alignment are usually good enough for service with the Muncie and with a bronze bushing they are trouble free and easy to service. Newer reproduction bell housings or aftermarket bell housings are more frequently out of alignment enough to need offset pins to correct it.
The newer design Tremec transmissions use a tapered roller front bearing that is more intolerant of bell housing runout so it needs to be checked and corrected before buttoning it all together.
As for the pilot bearing vs bushing - the bushing works great and is easy to remove and install. The bearing is more difficult to remove, more intolerant of misalignment and does not bring anything to the table so....Why would anyone prefer a pilot bearing? JMO.