1
General Discussion / Re: 69 starter solenoid wiring harness retainer
« on: March 04, 2025, 05:37:07 AM »
The smaller loop may just be for tension.
News:
Welcome to the CRG Discussion Forum!
Classified ads are not allowed on the forum.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
2
General Discussion / Re: Grandfather's '68.
« on: February 25, 2025, 05:39:39 AM »
Sorry to hear of your loss. It's nice to see that you updated this post though. Hang in there, and keep the dream alive!
3
Decoding/Numbers / Re: Help to verify 1968 z28
« on: February 20, 2025, 04:52:48 AM »
Based on the documents you posted, it appears to be a Z28.
4
Promotional Events and Concept Cars / Re: Bridgehampton: 1969 Camaro RS/SS 396 Z11 conv. Pace Car for SCCA Can-Am
« on: February 09, 2025, 06:17:36 AM »
Really cool stuff Scott!!
5
General Discussion / Re: Site Migration
« on: January 25, 2025, 06:17:35 AM »
Seems positive so far. Thanks for your efforts Doug!
6
General Discussion / Re: VIN Lookup and VIN Decoder sites
« on: January 25, 2025, 06:15:31 AM »
Personally, I don't think they can be taken seriously. It seems that every post I have seen about these sites in previous years, say the car in question is a 396. There were two posted here just today.
7
Decoding/Numbers / Re: Decoding my New 1967 SS
« on: January 25, 2025, 05:51:56 AM »
You are correct that the build is late, and would not represent that P was a 396. It is a really nice looking car though and should be a lot of fun to show and have fun with. As for vin reporting services, don't rely on the results.
8
Trans-Am Camaros / Re: Robert Barg R.I.P.
« on: January 17, 2025, 04:01:38 AM »
Wow, very sad and sudden news indeed. I always enjoyed his contributions here. Condolences to his family and friends. RIP
9
Restoration / Re: Window Regulator Roller Repairs
« on: December 30, 2024, 03:57:57 AM »
Nicely done and very helpful!
10
Originality / Re: Need Help Identifying This Hole
« on: December 13, 2024, 05:45:52 AM »
Yeah, it's not like they didn't have enough time to change it if they wanted.
11
Originality / Re: Need Help Identifying This Hole
« on: December 12, 2024, 06:39:28 AM »
Surprising. Would never have imagined 69's were handled differently than 67"s. Apologies for the misunderstanding.
13
Originality / Re: Need Help Identifying This Hole
« on: December 10, 2024, 07:06:34 AM »The factory used a torch to cutout the 4 speed transmission hole in the floorpan
Again, no.
14
Originality / Re: Need Help Identifying This Hole
« on: December 09, 2024, 04:39:41 AM »
Hard to believe that would have happened at the factory.
15