Rear sub frame bolt tape

[Boston14]

Steve, John Z stated that the tape was for a water test on the Fisher Body side before the body came through to the Chevrolet side.  Therefore it was a Fisher Body operation and would not appear in the 69 AIM.  Hope this helps.

boston14

[m22mike]

That is correct, would not be in the AIM.
The tape in question here, you may have seen it holding the paper door water shields in place ? It was a very thin and cheap paper tape, I dought if it was anything like gaffers tape Charley. I have also found bits of it on the heater box to hold the sponge seal it place that is around the heater core outlet tubes.

Mike

re; AMK pg 176 5/8'' and 2'' black tape

http://www.amkproducts.com/Catalog_PDF/165-176.pdf

[Charley]

Yes gaffers tape is too thick. Here is some tape still on the rear shock hole and it is barely thicker than paper. Notice it has a sheen to it.

[Ed Bertrand]

Notice it has a sheen to it.

Charley, is that gloss or semi-gloss??

 

Sorry pal, I couldn't resist.

Ed

[JohnZ]

I see there is a pic there labelled as a 69.. (Thanks M22Mike) ..but the 69 AIM (UPC 1-D1) makes no mention of the tape in it's illustration or components list.
Are we sure it's also a 69 detail? 

The tape used to seal that hole for water test was a Fisher Body item, so it wouldn't appear in the Assembly Manual.

[BlackoutSteve]

Thanks Guys.
It was Chick's 3rd post in this thread with what looks like an AIM page with tape wrapping the bushings that had me confused. I thought that was the tape in question.
Anyway, I (also?) assumed it's purpose was to hold the bushings during assembly -post Fisher. ..and didn't thoroughly read the following posts. 

[IZRSSS]

Notice it has a sheen to it.

Charley, is that gloss or semi-gloss??
 
Sorry pal, I couldn't resist.
Ed

Pretty certain its Gloss-Semi...although the back is Flat-Shag  ...

[68camaroz28]

Thanks Guys.
It was Chick's 3rd post in this thread with what looks like an AIM page with tape wrapping the bushings that had me confused. I thought that was the tape in question.
Anyway, I (also?) assumed it's purpose was to hold the bushings during assembly -post Fisher. ..and didn't thoroughly read the following posts.

That picture Steve came with a Quanta 68 marking kit and was noted as "Technical Bullentin #69". They have several (8 or 9) of these "Technical Bullentin" numbered forms and many of them are confirmed with what I have found on our car and read what others have found. Have no idea to how correct or not on this particular bullentin #69.