Author Topic: My New '68 Camaro Z/28 Butternut Yellow  (Read 50877 times)

ZLP955

  • Hero Member
  • *****
  • Posts: 787
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #60 on: July 19, 2014, 03:22:04 AM »
Danny the yellow markings on the subframe is the date code, there was a thread on this subject here or at TC so I'll see if I can find & post the link. But from memory, the date codes pictured in that thread were on 69s and located on the drivers side where the bumper bracket attached.
Tim - 04A VN '69 z/28 69-69 715 ex-E/MP

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #61 on: July 19, 2014, 05:08:41 AM »
Hey George, yes it is a blast. I am not feeling to bad. Don't have the strength I did but making it happen the best I can. Trying to forget about the 66 THOUSAND dollars in hospital bills, AFTER insurance. The girlfriend is awesome! And for sure a keeper. Thanx...

 ZLP I figured it was some kind of a date code of course cause it has a '68 at the end. But I had never seen anything like this. This car has a lot of cool stuff when it comes to numbers. More to come.

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #62 on: July 19, 2014, 05:19:01 AM »
Pitman arm, Idler arm, Motor mounts, Steering arms, Caliper brackets, Backing plates

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #63 on: July 19, 2014, 05:21:52 AM »
more, Coil Ballast Resistor marked Delco Remy,

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #64 on: July 19, 2014, 05:25:10 AM »
Inside front fender, mounting fasteners of Z/28 Emblems

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #65 on: July 19, 2014, 05:30:31 AM »
more steering and front end part numbers

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #66 on: July 19, 2014, 05:36:33 AM »
more... Piece of black tape under right side of deck lid under spoiler. But not on left side?

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #67 on: July 19, 2014, 05:38:15 AM »
more
« Last Edit: July 19, 2014, 06:15:48 AM by dannystarr »

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #68 on: July 19, 2014, 05:44:35 AM »
under rear spoiler

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #69 on: July 19, 2014, 05:50:52 AM »
Voltage Regulator, Horn Relay

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #70 on: July 19, 2014, 05:51:42 AM »
more

ZLP955

  • Hero Member
  • *****
  • Posts: 787
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #71 on: July 19, 2014, 05:56:01 AM »
Danny, found the thread discussing subframe markings - link here:
http://www.camaros.org/forum/index.php?topic=11678.0
Tim - 04A VN '69 z/28 69-69 715 ex-E/MP

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #72 on: July 19, 2014, 06:01:19 AM »
Awesome, thank you, will go there now and check it out... Then gotta hit the sheets...

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #73 on: July 19, 2014, 06:17:01 AM »
Rear Brake Drums and 46 Year Old Brake drum " BU " Sticker - Right Side
« Last Edit: July 19, 2014, 06:54:28 AM by dannystarr »

dannystarr

  • Hero Member
  • *****
  • Posts: 1121
    • View Profile
Re: My New '68 Camaro Z/28 Butternut Yellow
« Reply #74 on: July 19, 2014, 06:22:40 AM »
Starter and solenoid - Starter Support Stabilizer Bracket
« Last Edit: July 19, 2014, 06:53:03 AM by dannystarr »