Topics

1

Decoding/Numbers / Speedo cable Codes

« on: September 05, 2020, 06:24:17 PM »

I am cleaning out my garage and have come across some left over speedo cables-I believe they are all from 67-69 camaros -but could be wrong-any idea on the code stamped on them

BB
CA
CT
Thanks in advance-Stay safe everyone!
Keep on Cruising!
Dave

2

Decoding/Numbers / Space Saving Tire

« on: July 15, 2018, 01:32:36 AM »

Can anyone decode this tire/rim M 35   10 30 RG
Thanks in advance!
Keep on Cruising!
Dave

3

Decoding/Numbers / Z bar frame bracket stamping

« on: September 23, 2017, 09:48:18 PM »

I picked up a Z bar frame bracket at a local swap meet-it has CHQ stamped on it-is this an original gm piece or a reproduction?Thanks for any input!!!
Keep on cruising!
Dave

4

Garage Talk / Keith Chevrolet Circa 1969

« on: April 27, 2016, 07:02:30 PM »

I was looking at a NOS gm box and noticed a postage stamped from Oakland,CA dated October 31,1969 -I guess Gm mailed parts back then- it was shipped from General Motors Parts Division in Oakland,Ca to a Keith Chevrolet-the res is hard to make out but I think it is Chester,PA or Chester(another state)-I take it this dealership isn't in business or the name has changed-any info would be appreciated!
Keep on Cruising!!!
Dave

5

General Discussion / 1970 Chevrolet Dealer/Sales Album

« on: December 06, 2015, 04:56:02 PM »

I recently picked up a mint 1970 dealer album.It does not have any camaro or corvette info in it due to the strike  I guess as all it reads is information will be added later..It must be one of the early ones put out-just curious when they added the info on the camaro and corvette to this book .Nice reading material.Thanks for any input.
Keep on Cruising!
Dave

6

Originality / Factory motor mounts

« on: November 11, 2015, 02:51:12 AM »

I picked up a box full of camaro parts from a guy-I got a mint set of 3950113/114 69 bb frame mounts and a pair of nos in gm boxes #3990916 engine mounts-1  nos # 6258154 in gm box mount and 2 mint /used #330973 engine mounts-any idea which mounts were installed at the factory? Thanks in advance!
Keep on Cruising!!!
Dave

7

Decoding/Numbers / Stewart Warner Gear Reduction

« on: September 13, 2015, 09:10:52 PM »

Cleaning out my toolbox in the garage-found  a Stewart Warner gear/speedo reduction unit has .9743 Y stamped on it-any idea what it is from?Thanks in advance!!!!It may be from a 70 gm pick up-not sure.
Keep on Cruising!!
Dave

8

Originality / #20037597 inside window handles with black knobs

« on: August 08, 2015, 06:22:20 PM »

I know most came with clear knobs and are expensive to find NOS  but what would a set of NOS black knob handles fit and be worth? Thanks in advance!
Keep on Cruising!
Dave

9

Originality / Original Cowl Induction Throttle Arm

« on: August 08, 2015, 01:03:44 PM »

Is there any way to tell an original or gm piece from a reproduction-was at a friends house and he had a cowl induction throttle arm-he wasn't sure if it was a reproduction or not-the only stamping I saw was  "C" stamped on it-whats a gm one worth?Thanks in advance!
Keep on Cruising!

Dave

10

Originality / "W" stamped on the cowl induction flange

« on: August 19, 2014, 06:37:03 PM »

 I replaced the 69Z28 cowl induction flange on my chevelle with a NOS correct notch/cut off type correct for chevelles-the camaro one I have had for many years it has a "W" stamped on it -I take it it is a manufactures stamp-any idea who made these. Only idea I had many Winters-but I know they were a foundry-are these camaro flanges worth any more than the chevelle ones? Thanks in advance!
Keep on Cruising!

Dave

11

Originality / Did all cowl induction air cleaners have the vent tube??

« on: July 10, 2014, 05:51:03 PM »

I went to look at some bumoers for my sons 67RS.Started talking with the guy and he said he had a cowl induction air cleaner that he took off a 69 Camaro 30 years ago. It apperars to be a flat bottom one but when I flipped it over there was no vent tube? The snout looked like a Gm one-maybe it was for something else. Sorry my camera died so no pictures. May go back though. Thanks in advance for all your inut!

Dave

12

Originality / Did all 69Z28 cowl induction breathers have a flat bottom ?

« on: September 12, 2013, 08:33:23 PM »

Did all the 69Z28 cars have the flat bottom cowl induction ait breathers ?I know the ridge bottom ones were service replacement-Just curious if they had  switched anytime -thanks for any input!
Dave

13

Decoding/Numbers / Shifter Rods I.D

« on: July 31, 2013, 11:54:10 PM »

First off I want to say this is a great site!Been lurking here a while-finally signed up-Many know me from the Chevelle forums -but I have start working on my sons 67 RS 327 -it is a roller right now-anyway it came with a m21 tranny(don't think it is the original one) -in a box I found a shifter-the rods have #6004,6005,6065 stamped on them-any idea what they are off of?Thanks in advance!!!!!
Keep on Cruising!!!!!!
Dave