Author Topic: 1968 Z/28 stripe question  (Read 2797 times)

Dockroger

  • Newbie
  • *
  • Posts: 9
    • View Profile
1968 Z/28 stripe question
« on: May 05, 2012, 12:56:27 AM »
Mr. MacNeish's 1967-1968 Camaro Z/28 fact book shows the front edge of the stripe below the rear window as being straight.
The stencil kit that I purchased has it curving down slightly towards the back of the car
What's correct?

Jon Mello

  • CRG Member
  • *****
  • Posts: 4413
    • View Profile
Re: 1968 Z/28 stripe question
« Reply #1 on: May 05, 2012, 04:53:55 PM »
The stencil kit is not a perfect solution. I do seem to recall the middle wanting to curve down when I tried to lay out the stencils. It's been a couple of years but I remember the painter and I did a little trimming, cutting and adjusting on the stencil to get the part above the trunk lid to look right.
Jon Mello
CRG

Dockroger

  • Newbie
  • *
  • Posts: 9
    • View Profile
Re: 1968 Z/28 stripe question
« Reply #2 on: May 05, 2012, 05:03:17 PM »

I think the photo will help
Thanks

Jon Mello

  • CRG Member
  • *****
  • Posts: 4413
    • View Profile
Re: 1968 Z/28 stripe question
« Reply #3 on: May 05, 2012, 05:42:22 PM »
You're welcome.
Jon Mello
CRG

 

anything