CRG Discussion Forum
Camaro Research Group Discussion => Restoration => Topic started by: Dockroger on May 05, 2012, 12:56:27 AM
-
Mr. MacNeish's 1967-1968 Camaro Z/28 fact book shows the front edge of the stripe below the rear window as being straight.
The stencil kit that I purchased has it curving down slightly towards the back of the car
What's correct?
-
The stencil kit is not a perfect solution. I do seem to recall the middle wanting to curve down when I tried to lay out the stencils. It's been a couple of years but I remember the painter and I did a little trimming, cutting and adjusting on the stencil to get the part above the trunk lid to look right.
-
I think the photo will help
Thanks
-
You're welcome.