« previous next »
Pages: 1 2 3 [4]  All

Author Topic: Factory rear sway bar set-up, 1967  (Read 39784 times)

Jon Mello

  • CRG Member
  • *****
  • Posts: 4415
    • View Profile
Re: Factory rear sway bar set-up, 1967
« Reply #45 on: September 27, 2014, 04:37:46 PM »
You're welcome, Max.

Below is a photo showing the holes in the rear subframe where the flat u-bolt goes through. The front of the car would be to the right.
Logged
Jon Mello
CRG

Jon Mello

  • CRG Member
  • *****
  • Posts: 4415
    • View Profile
Re: Factory rear sway bar set-up, 1967
« Reply #46 on: September 28, 2014, 05:01:28 AM »
Another vintage rear sway bar for an early Camaro, again from the Robert Lodewyk collection. The name of the manufacturer is unknown.
The width of the sway bar is 34" across and the vertical links appear to bolt through the side of the rear frame rails.













Looks like a Supertanium bolt connecting the bar to the vertical link...


A closer look at the clamps that bolt around the rear axle tubes and hold the sway bar in position.
Logged
Jon Mello
CRG

Jon Mello

  • CRG Member
  • *****
  • Posts: 4415
    • View Profile
Re: Factory rear sway bar set-up, 1967
« Reply #47 on: September 28, 2014, 05:05:05 AM »
Here's a side-by-side comparison of Robert's two different styles of aftermarket rear sway bars...





Logged
Jon Mello
CRG
Pages: 1 2 3 [4]  All
« previous next »