CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
April 25, 2015, 09:27:36 AM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
112272 Posts in 12899 Topics by 4936 Members
Latest Member: Rallyred
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Mild Modifications
| | |-+  Exhaust routing on a 67 convertible
« previous next »
Pages: [1] Print
Author Topic: Exhaust routing on a 67 convertible  (Read 1210 times)
Posts: 58

View Profile Email
« on: January 20, 2009, 01:33:38 AM »

Hi guys
I have a small block with headders and try to figure out how to route my new exhaust (universal parts) in a proper way. I dont stribe for originality.
There is a lot of aftermarket systems to buy but normally they say "not for convertible". I want a 2.5" system. The output of
the headders is in line with the mid floor reinforcement and I have to angle the tube down to avoid a collision and then it goes up
again before the rear axle. I wanted to place the tubes inside the floor X-brace but the clearance to the floor was not good enough.

The bottom line is that I shure should appriciate some images on exhaust on thoose cars to get some ideas how to proceed with my work. Huh Huh

Thanks /Emanuel
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.20 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.068 seconds with 17 queries.