|
wrsctv
|
 |
« on: January 27, 2008, 08:34:11 PM » |
|
How is the 396 flag decal positioned in relation to the 396-375 hp decal on the lid of the chrome air filter. Some I have seen centered but some I have seen are off set to one side. Any help for this newbie? Thanks
|
|
|
|
|
Logged
|
|
|
|
|
68Zproject
|
|
« Reply #1 on: January 27, 2008, 11:10:01 PM » |
|
Doesn't the lid turn around if it's loose?
|
|
|
|
|
Logged
|
68Z28
|
|
|
|
wrsctv
|
|
« Reply #2 on: January 28, 2008, 05:59:25 AM » |
|
Yes but both decals are mounted on the lid. It is an open element breather. Thanks
|
|
|
|
|
Logged
|
|
|
|
|
GaryL
|
|
« Reply #3 on: January 28, 2008, 10:08:57 AM » |
|
It may be shown in the AIM. The 302 decal is shown there.
|
|
|
|
|
Logged
|
Gary
Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.
|
|
|
|
JohnZ
|
|
« Reply #4 on: January 28, 2008, 12:07:01 PM » |
|
See the Assembly Manual, section L78, Sheet A5 (assuming it's a '69 - it would help if you'd indicate what year car you're asking about).
|
|
|
|
|
Logged
|
'69 Z/28
Fathom Green
CRG
|
|
|
|
wrsctv
|
|
« Reply #5 on: January 28, 2008, 04:59:45 PM » |
|
It is a 1968 Camaro 396-375 if that will help. Thanks
|
|
|
|
|
Logged
|
|
|
|
|
Ed Bertrand
|
|
« Reply #6 on: January 28, 2008, 06:52:28 PM » |
|
It's on page L34-A3, page L78-A1 and on page L78-A6, but this is how it should be positioned: Ed By the way, the Z28 is positioned different than the big blocks. At least for 1968...  |
|
|
|
|
Logged
|
Ed Bertrand
CRG Member
|
|
|
|
wrsctv
|
|
« Reply #7 on: January 28, 2008, 07:47:47 PM » |
|
Ed Thanks for the picture. It shows the 396 decal in the middle which makes sense but I had seen one off set which didnt look correct but I wasnt sure whether it was correct or not. Its trivial but I wanted it correct. Thanks loads.
|
|
|
|
|
Logged
|
|
|
|
|
Ed Bertrand
|
|
« Reply #8 on: January 28, 2008, 08:31:06 PM » |
|
Yes, the AIM (page L34-A3) shows that both decals are placed center line of the engine. The L78 page doesn't show the measurement, but it's the same as the L34.
Glad to be of service
Ed
|
|
|
|
|
Logged
|
Ed Bertrand
CRG Member
|
|
|
|
1968RSZ28
|
|
« Reply #9 on: January 28, 2008, 08:34:32 PM » |
|
It's on page L34-A3, page L78-A1 and on page L78-A6, but this is how it should be positioned: Ed By the way, the Z28 is positioned different than the big blocks. At least for 1968... Ed - So are the photos on pages 97 & 98 in F.J.R. Incremona's 1967-1969 Camaro Fact Book incorrect? His photos show the "396" decal closer to the air cleaner wing nut. Paul |
|
|
|
|
Logged
|
|
|
|
|
1968RSZ28
|
|
« Reply #10 on: January 29, 2008, 06:50:58 PM » |
|
Anybody else know which way is correct?
Paul
|
|
|
|
|
Logged
|
|
|
|
|
Ed Bertrand
|
|
« Reply #11 on: January 29, 2008, 07:58:01 PM » |
|
Here's a picture of an original L35 engine compartment from 1968. I've also enlarged just the filter. Ed   |
|
|
|
|
Logged
|
Ed Bertrand
CRG Member
|
|
|
|
1968RSZ28
|
|
« Reply #12 on: February 01, 2008, 07:07:48 PM » |
|
Thanks Ed! At this stage I will assume the photos in Incremona's book are wrong and the car pictured in his book has been restored incorrectly.  Paul |
|
|
|
|
Logged
|
|
|
|
|
68 RS/SS Ragtop
|
|
« Reply #13 on: August 13, 2011, 09:47:52 AM » |
|
How about for a small block open air filter for SS350? Was the decal close to the edge, centered or close to the wingnut?
|
|
|
|
|
Logged
|
|
|
|
|
JohnZ
|
|
« Reply #14 on: August 13, 2011, 10:35:43 AM » |
|
How about for a small block open air filter for SS350? Was the decal close to the edge, centered or close to the wingnut?
I've never seen an L48 with an open-element air cleaner; the Assembly Manual shows all L48's with closed "snorkel" air cleaners. |
|
|
|
|
Logged
|
'69 Z/28
Fathom Green
CRG
|
|
|
|
CRG Discussion Forum
Author
