i have a question , when i look at the AIM UPC 14 for my 67 rear bumper , the screw at the corner is located at the top of the bumper. but on my export model the screw is below the bumper
where are yours??? is it possible that the export model have a special bumper ? or a mistake in the AIM?
and for the front bumper ,there are no hole below the bumper in the corner (and no screw just like 68 models) and it not seem to be a 68 model because i dont have the 3 holes near the license plate ....( just one for the braket)
and a friend have the same configuration on his 67 export model ( but he have repro bumpers)