CRG Discussion Forum
Camaro Research Group Discussion => Originality => Topic started by: philip on March 14, 2014, 10:34:33 AM
-
Hi
i have a question , when i look at the AIM UPC 14 for my 67 rear bumper , the screw at the corner is located at the top of the bumper. but on my export model the screw is below the bumper ????
where are yours??? is it possible that the export model have a special bumper ? or a mistake in the AIM?
and for the front bumper ,there are no hole below the bumper in the corner (and no screw just like 68 models) and it not seem to be a 68 model because i dont have the 3 holes near the license plate ....( just one for the braket)
and a friend have the same configuration on his 67 export model ( but he have repro bumpers)
thanks
-
The 3 hole by the license bracket is the 67 bumper, I thought?
-
No, 68'look 1b
http://www.camaros.org/exterior.shtml#6768bumper
-
Hi
i have a question , when i look at the AIM UPC 14 for my 67 rear bumper , the screw at the corner is located at the top of the bumper. but on my export model the screw is below the bumper ????
where are yours??? is it possible that the export model have a special bumper ? or a mistake in the AIM?
thanks
The rear bumper has a drawing error in the 1967 and 1968 assembly manual. It is correctly drawn in the 1969 version.
-
Thanks!
So no special bumper for export.