Author Topic: 68 Camaro Center Rear Bumper Bracket Grommet  (Read 1054 times)

68rs327conv

  • Member
  • ***
  • Posts: 111
    • View Profile
    • The build
68 Camaro Center Rear Bumper Bracket Grommet
« on: September 21, 2013, 02:43:29 AM »
Any suggestions on where I can get the rubber grommet for the center rear bumper bracket on a 68 camaro.  The license lamp wire goes thru the bumper bracket which has a rubber grommet.

It is GM 1367472 and is listed in the AIM on page 172 UPC12 C4 Rear License Lamp.

A source for a used one would be great also

Any help is greatly appreciated

Mike
Mike
68 RS Conv 327/210hp, Powerglide Factory AC

68Zproject

  • Hero Member
  • *****
  • Posts: 1634
    • View Profile
Re: 68 Camaro Center Rear Bumper Bracket Grommet
« Reply #1 on: September 22, 2013, 06:11:07 AM »
Have you tried AMK?
68Z28

68rs327conv

  • Member
  • ***
  • Posts: 111
    • View Profile
    • The build
Re: 68 Camaro Center Rear Bumper Bracket Grommet
« Reply #2 on: September 22, 2013, 12:39:01 PM »
Yes, not listed in their catalog or online.  It is a 1" diameter hole, I picked up a rubber grommet from Lowes which I will try and should keep the wire from rubbing on the bracket, but prefer original if possible.

Mike
Mike
68 RS Conv 327/210hp, Powerglide Factory AC

jeff68

  • Member
  • ***
  • Posts: 363
    • View Profile
Re: 68 Camaro Center Rear Bumper Bracket Grommet
« Reply #3 on: October 10, 2013, 04:30:44 PM »
My 68 had a plastic grommet in this hole.  Not sure where to get one.
68 L30 / M20 Convertible
Ash Gold

MyRed67

  • Hero Member
  • *****
  • Posts: 774
  • SZZLN 67
    • View Profile
Re: 68 Camaro Center Rear Bumper Bracket Grommet
« Reply #4 on: October 11, 2013, 12:32:41 AM »
My 68 had a plastic grommet in this hole.  Not sure where to get one.
  I agree with jeff68, my '67 also had the plastic grommet.  These are usually not in bad shape, in kind of a well protected area.
1967 Camaro  LOS  11A
Original Engine   Z - Tribute
Mike C.    NW - Illinois