CRG Discussion Forum

Camaro Research Group Discussion => Originality => Topic started by: 68rs327conv on September 21, 2013, 02:43:29 AM

Title: 68 Camaro Center Rear Bumper Bracket Grommet
Post by: 68rs327conv on September 21, 2013, 02:43:29 AM

Any suggestions on where I can get the rubber grommet for the center rear bumper bracket on a 68 camaro.  The license lamp wire goes thru the bumper bracket which has a rubber grommet.

It is GM 1367472 and is listed in the AIM on page 172 UPC12 C4 Rear License Lamp.

A source for a used one would be great also

Any help is greatly appreciated

Mike

Title: Re: 68 Camaro Center Rear Bumper Bracket Grommet
Post by: 68Zproject on September 22, 2013, 06:11:07 AM

Have you tried AMK?

Title: Re: 68 Camaro Center Rear Bumper Bracket Grommet
Post by: 68rs327conv on September 22, 2013, 12:39:01 PM

Yes, not listed in their catalog or online.  It is a 1" diameter hole, I picked up a rubber grommet from Lowes which I will try and should keep the wire from rubbing on the bracket, but prefer original if possible.

Mike

Title: Re: 68 Camaro Center Rear Bumper Bracket Grommet
Post by: jeff68 on October 10, 2013, 04:30:44 PM

My 68 had a plastic grommet in this hole.  Not sure where to get one.

Title: Re: 68 Camaro Center Rear Bumper Bracket Grommet
Post by: MyRed67 on October 11, 2013, 12:32:41 AM

Quote from: jeff68 on October 10, 2013, 04:30:44 PM

My 68 had a plastic grommet in this hole.  Not sure where to get one.

  I agree with jeff68, my '67 also had the plastic grommet.  These are usually not in bad shape, in kind of a well protected area.