D80 included???

[mopar346]

Glad everyone is back. I actually finally looked this week end and it has the hole in the subframe. The picture above isn't showing anymore but I believe its the correct one. Did anything else come with the D80 option or just front and rear spoilers?

[JohnZ]

Glad everyone is back. I actually finally looked this week end and it has the hole in the subframe. The picture above isn't showing anymore but I believe its the correct one. Did anything else come with the D80 option or just front and rear spoilers?

Nope - just the spoilers.

[mopar346]

Thanks, the picture came through tonight and it is the correct hole.

[tryconcom]

When did  d80 become standard? and was it coded into the trim tag?

[Gramps69Z]

Spoilers (D80): The spoiler option was not available in 1967 on any Camaro. It became available as an option on all cars (except those with a rear antenna) in 68-69. It was not mandatory on any car, except for the 69 pace car replicas and later 69 Z's.
Per production options: CRG

Here's a picture of my tag with the D80.

[L78 steve]

Is the bolt supposed to be pointing down as in the picture? Looks like a hazzard when sliding under on a creeper.

[JohnZ]

Is the bolt supposed to be pointing down as in the picture? Looks like a hazzard when sliding under on a creeper.

If you're asking about the center brace rod-to-subframe attachment, that's the way it was designed; see the Assembly Manual.

[L78 steve]

I guess I need to turn mine around.

[L78 steve]

Is that hole only on D80 cars? Or on all subframes?

[Sauron327]

A subframe was not D80 prejudiced, none had the hole until the spoiler was mounted.

[JohnZ]

Is that hole only on D80 cars? Or on all subframes?

The subframe hole was drilled using the brace rod as the drill fixture, as shown in the Assembly Manual.

[L78 steve]

Had a look at mine. It does not have the 5/16 nut and bolt as shown in the pic. above. It has a 1/4 self tapping screw installed. Hole is to small for the 5/16 bolt. A variation?

[jacmac]

 I notice your bolt drops in from the top & a nut is added.On my 69Z10 the subframe is treaded & the bolt just screws in to the frame to hold the spoiler bracket on??

<<Also look for a hole in the front subframe for the center support bar for the front spoiler. Someone here probably has a pic.>>

Here's a photo of the center support rod attachment to the subframe.

[Gramps69Z]

I doubt it's threaded, I bet it's a self tapping screw,

[L78 steve]

I doubt it's threaded, I bet it's a self tapping screw,

As is mine.