Possible find 67 L30/M20

[Jeffro67]

Jeffs 67.

[Jeffro67]

Jeffs 67.

[Jeffro67]

Jeffs 67.

[Jeffro67]

Ok, newbie is a perfect name for me. On theese last two pics I found out how to reduce them way further.

Jeffs 67.

[rare4k]

I think the rear is wrong just by date, should be a 12 bolt round bar,Ithink the car may have had a saginaw trans thats why the cable is on the drivers side, I haven't seen a saginaw in along time I can't remember what side it's on, Also just a NOTE you have a big block cross member  great color when done

[Jeffro67]

Thanks, I agree, I have seen a few pictures of Mountain Green cars and I like them.
What is the difference between big block and small block cross members?

Jeff.

[Jeffro67]

Hey all, I was just researching the forum and I noticed that my early 67 has the same plastic speedo cable plug in the same hole (just above and right of throttle lever) as qwertyme77 posted under decoding/numbers board on March 26. What's up?

Jeff.

[Jeffro67]

Does anyone know if GM used different size fuel lines on 67 models for different engine applications?

Jeff.

[Jeffro67]

It looks like (qwertyme77) 67 is very close to mine. His has a tag build of 01B and my car is 02B and both 4 speed cars. Does any one know if I can message him directly so I can catalog the similarities?

Jeff.

[1968RSZ28]

Does any one know if I can message him directly so I can catalog the similarities?

Sure, just click on his user id, then on "send this member a personal message".

Paul

[Stillwater Camaro]

Hey all, I was just researching the forum and I noticed that my early 67 has the same plastic speedo cable plug in the same hole (just above and right of throttle lever) as qwertyme77 posted under decoding/numbers board on March 26. What's up?

Jeff.

That's not a speedo cable plug. It is a 2 wire electrical bulkhead connector.

[Jeffro67]

Thanks for clarifying that electrical connector for me, I can clearly see the other two holes now.

Jeff.

[68Zproject]

Reverse light hookup

[Jeffro67]

Can anybody direct me to a picture of a 67 radius rod (bracket) that is allready bolted to the bottom of the floor pan?

[1968RSZ28]

Can anybody direct me to a picture of a 67 radius rod (bracket) that is allready bolted to the bottom of the floor pan?

Sure, see page 81 in Jerry MacNeish's "The Definitive 1967-1968 Camaro Z/28 Fact Book", third edition.     

Paul