Fender Camaro Emblem on SS

[srode]

What's the correct placement for the Camaro Emblem on an SS car?  I have an original fender (I think) to use to create a template on a virgin OEM fender for holes, but on the original the holes look like it will not place the emblem straight, instead a little at an angle (slightly).  Are these supposed to be straight / parallel to the fender line and the ground or a little at an angle?  Also, is the placement the same on an SS and a non SS car? 

Thanks, Steve

[IZRSSS]

Maybe this will help...

[IZRSSS]

And...

[IZRSSS]

Measurements...

[Stingr69]

Those AIM dimensions are near worthless. They all reference from a pair of imaginary lines that you do not have.

-Mark.

[srode]

The picture is helpful as are the hole sizes.  I have to admit looking at the AIM dimensions I am lost as to how to use them other than as a template creator - the tilt and location aren't really specified.  Looks from the picture to level not tilted any. 

[JohnZ]

The body inch lines (designated by the numbers in the circles) were part of the GM Body Dimensional Grid system, which was used to set the body up on a surface plate for height-gage measurement vs. the design master. Those inch lines are perfectly vertical and horizontal in a 3-dimensional grid system.

[srode]

thanks John, I that helps decipher the information - I'll take it over to the shop this morning.

Steve

[IZRSSS]

I believe these are the two main reference points...

X and Y axes {15 & +5} are there simply to keep your holes perpendicular to one another...