Endura bumper jacking instructions - different then standard bumpers?

smith69z · August 19, 2009, 02:16:56 PM

Did GM have a different sticker on the trunk lid for endura bumper equipped cars? And if so does anyone reproduce them?

JohnZ · August 20, 2009, 10:18:49 AM

The Assembly Manual doesn't show a unique-to-VE3 jack instruction sticker either in the VE3 section or in the UPC 10 jack section.

smith69z · August 23, 2009, 05:54:47 AM

Thank you for your time to answer John. I have been holding off on this sticker until I was sure.

firstgenaddict · September 26, 2009, 02:06:12 AM

Here is an original paint VE3 vintage legend certified instructions

Oaklyss · September 26, 2009, 02:55:53 PM

Heres my original paint car, original VE3, jack sticker:

Oaklyss · September 26, 2009, 03:04:51 PM

Wait, heres a close up.

crobjones2 · September 26, 2009, 07:22:53 PM

does anybody have any pics of the ""straps" used to hold the wrench to the jack?

JohnZ · September 27, 2009, 09:31:37 AM

Quote from: Oaklyss on September 26, 2009, 03:04:51 PM
Wait, heres a close up.

That's the standard jack instruction sticker - same as my original non-VE3 '69 Z/28.

JohnZ · September 27, 2009, 09:32:50 AM

Quote from: crobjones2 on September 26, 2009, 07:22:53 PM
does anybody have any pics of the ""straps" used to hold the wrench to the jack?

Don't have a photo handy, but they're wide, heavy black rubber bands.

Oaklyss · September 27, 2009, 10:22:01 AM

My point is, they are the same. There is no speciial VE3 sticker.

smith69z · September 28, 2009, 04:26:33 PM

Thanks guys!!

News: