News:

Classified ads are not allowed on the forum.

Main Menu

AM radio light

Started by GaryL, April 19, 2008, 07:02:32 PM

Previous topic - Next topic

GaryL

Some how my light bulb connector became disconnected from the radio housing. I can not figure out which hole it plugs in to. Nothing gives me light. The bulb is good. Can anyone give me the right hole? Top, bottom end? :-[
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.

68Zproject

Off the top of my head, it went in the passenger side at an angle off of the front plate.  That's going back a few years though.
68Z28

GaryL

Turns out it is not the radio light. It is a single wire connector with prongs that connect into a metal housing to ground. Anyone have an idea?
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.

Marty

Martin Foltz
CRG Member
68 Van Nuys Camaro

68Zproject

68Z28

GaryL

I realized the radio light is plugged into the top of the radio. Now I have this connector that is single wire and the type that locks into a metal hole with prongs for grounding. It is not the heater control light. That is 2 wire like the speedo light. This is for a 1969 model.
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.

Flowjoe

Quote from: 68Zproject on April 23, 2008, 10:16:27 AM
Heater control light?
that's what I would have guessed - mine falls out and hangs above the console all the time

GaryL

No, it turned out to be an after-market light for a radio. Took it of and repaired the wiring.
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.