Info on 8N467701 ?

[Tx-Z 302]

Very rusty, required full floors, trunk pan, partial quarters, partial firewall, outer rockers. No it didn't have factory tach or a console the old floor appreared to have no provisions for console mount. Yes it has the correct old tire sticker that's litterally falling apart I have the glove box door carefully packed into a cardboard box for protection of the sticker it's very brittle.   I was considering putting a thin piece of lexan/plexiglass over the whole glove box back to protect what's left. Not sure if that's acceptableor not?

[Tx-Z 302]

The old floor did have the 4 spd ring on bottom which we carefully removed and relocated to the new floor pan

[Tx-Z 302]

trying to make axle stamp pic bigger let me know if it works

[BULLITT65]

So your doing a full on resto of this car then? Can you give us a hint of the MLB pitcher? (Team , what years played? just curious)

[bertfam]

No, the picture's the same size as before. Can you just email it to me? My email address is in my signature below.

Ed

[Tx-Z 302]

maybe now?? 50 percent on light image resizer is as big as it will accept on this site!!

[Tx-Z 302]

Ed, send me your email, when i click the link in your signature it takes me to outlook, i dont use outlook, not because its bad, i just dont know how, im a yahoo or aol guy because im old!!!!

[BULLITT65]

when it takes you to outlook, just copy and paste his email into your aol compose email page.

[Tx-Z 302]

Im in the process of restoration, but i want to determine if its a Z28 or and SS before I decide how to proceed with the restoration.

[Tx-Z 302]

says i have to "set up outlook"  id rather just stick his address in my camaro group on aol or yahoo. my daughter had to set that up, im that guy that likes to open a hood and just see an alternator and maybe an ac compressor!!   vacuum tubes and electrical wires and c omponents on every side of the engine bay wigs me out!!!!!!!!!!! lol

[bertfam]

PM sent with my email address

Ed

[Tx-Z 302]

thx ed i sent couple emails with pics

[bertfam]

Got em Chris. And from what I can see, it looks to me know you have the genuine article!! Congrats!

Ed