My New '68 Camaro Z/28 Butternut Yellow

[dannystarr]

more

[dannystarr]

more

[dannystarr]

more

[dannystarr]

more

[dannystarr]

Mounting Bolts.. Large hole

[dannystarr]

more

[dannystarr]

Small holes

[dannystarr]

Small mounting holes

[1968 Z28]

Yup, just is I thought, you have the short spoiler with no braces.....the same one that was on my 07C car.  The hardware is very interesting also....your car has the standard center bolt (5/16 shouldered) and the small hardware is shouldered screws.  My car has shouldered machine screws on the spoiler side and nuts on the valence side.  There have been several threads on the spoiler and the hardware and this shows that there were indeed two different types of mounting hardware, screws and machine screws with nuts.

Thanks so much for your time and effort for fulfilling our request.

[dannystarr]

No problem.. D

[1968RSZ28]

Better shots of distributor now that I pulled it. Sure hope it is original.

Distributor looks good, Danny.  Here's another 467 for comparison.

Paul

[dannystarr]

Yes I can see the 4 and the 7 have those distinctive markings in the corners, and the fonting matches nice. My date is spaced out a little more, but I have seen many like this. Sure we all have. Danny

[dannystarr]

Here is my balancer. Remember in a previous post we thought maybe it could have spun. Well here it is... The mark lines up perfect with the center of the keyway. Is this good to go?? Is this where it is when it leaves the assembly... ready for use? .. Danny

[maroman]

In your bottom pic it looks like the key is clocked. I HOPE that's an illusion. If not the key is about to shear.

[L78 steve]

Someone's had that off for some reason. It's been installed the old fashion way.