News:

Classified ads are not allowed on the forum.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - svtrich

#1
I cant believe Im the only person with a LA car? 
#2
I know the trunk paint on the norwood and la are different. what do I do for my la car
             thanks Richard
#3
I put 72 jets in the pri.76 in the sec. Im not running the 3030 cam but it dosent idle right.i adjusted the mixture screws but still it isnt right.still idles around 1000rpms
                     Rich
#4
Im just affraid that some of this repop stuff may look right but be a piece of junk

                                                     Richard                             
#5
does anyone sell one?
              Richard
#6
Are these things any good ? does anyone make a correct quality replacement ?
                                    Richard
#7
Im not looking to install the rivets.Im looking for correct looking ball joints for a 69
#8
Thank you everyone but its built and done.one more lite coat of paint and in it goes.I ended up using Speed Pro Plasma Moly rings and cleavite bearings
                                               Richard ;D
#9
I called Bairs,the ball joints that they use are made by Dana.he couldnt help for Camaro ball joints. :(
                     Richard
#10
I talked to Jim at Heartbeatcity.he said he has original type ball joints that will use rivets.MADE IN TURKEY??????????? I think I will pass.if my well falls over because of the ball joint.that wont be cool :'(   I might just use ac delco stuff and see how it goes.
                         
#11
after seeing these manifolds.I wonder if I should lightly bead blast it and put a thin coat of clear on it
                      Rich
#12
should I get mine media tumbled or just lightly blast it? what did a new one from the factory look like.
                      Richard ;D
#13
General Discussion / Re: headers
March 08, 2010, 12:55:26 AM
check DYNATECH for headers,they sell them at Summit
#14
John
do you know a fel pro part # that you can recommend?
                    Richard
#15
that doesnt tell me what gasket I should use