I blew that pic up to actual size and printed it. But because it is taken from a slight angle, it doesn't help me.
My car had no console, so I can't use those holes as a reference. A previous owner had cut most of the tunnel out for a straight line shifter, so I have no dimples. At first I thought the .905 measurement (just over 7/8) was an off set, but when I scribe using that much offset, it it obviously too much. I am guessing it is only about a half inch, but I only get one chance at this. I am not doing any more welding on the floor at this point.
I do still have the "V" shaped crease up ahead, so am able to locate the North South orientation. Just can't do the side to side.