CRG Discussion Forum
Welcome, Guest. Please login or register.
Did you miss your activation email?
September 17, 2014, 12:48:16 PM

Login with username, password and session length
Search:     Advanced search
Welcome to the CRG Discussion Forum!
Forum registration problems: Make sure you enter your email correctly and you check your spam box first. *Then* email KurtS2@gmail for help.
104483 Posts in 12234 Topics by 4716 Members
Latest Member: Hgtech
* Home Help Search Login Register
+  CRG Discussion Forum
|-+  Camaro Research Group Discussion
| |-+  Restoration
| | |-+  68 RS fenderwells
« previous next »
Pages: [1] Print
Author Topic: 68 RS fenderwells  (Read 2970 times)
68rsssrag
Member
***
Posts: 135


View Profile
« on: October 27, 2005, 08:19:58 PM »

Anyone out there have any measurements fro how to drill the GM NOS fenderwells to allow hideaway headlights. I bought these from GM in 1983, finally mounted them yesterday but, oopps, realize now that GM supplies them without the bracket holes, actuator hole, and actuator bracket holes. Ugh.

Arno
Logged
Leonard1
Member
***
Posts: 30


View Profile
« Reply #1 on: October 28, 2005, 07:28:18 AM »

I think the AIM gives pretty detailed information on this.  I know that for some holes there are dimples to mark the location. 
Logged
KevinK
Member
***
Posts: 232



View Profile WWW Email
« Reply #2 on: October 28, 2005, 08:36:41 AM »

Anyone out there have any measurements fro how to drill the GM NOS fenderwells to allow hideaway headlights. I bought these from GM in 1983, finally mounted them yesterday but, oopps, realize now that GM supplies them without the bracket holes, actuator hole, and actuator bracket holes. Ugh.

Arno


   As above, ...the Assembly Manual is a good starting point, ...and there are dimples. If you'd like, ...I've got an original set (in the attic) that I could take a few measurements on.
Logged
68rsssrag
Member
***
Posts: 135


View Profile
« Reply #3 on: October 28, 2005, 10:31:06 AM »

Hi Kevin

I'm looking at the AIM in the Z22 RPO pages and do not see any dimensions or "punch at dimple" notes. There is nothing like the firewall pictorial either.

If you can provide me with some reference measurements from your old set I would be very grateful. I think there are 3 major items I need location of ;
1. large hole for crank rod on rounded part of the fenderwell near front
2. 2 bolt holes for this cranks bracket
3. 2 bolt holes for the cross brace that secures the vac cannister

Thanks

Arno
Logged
Pages: [1] Print 
« previous next »
Jump to:  

Powered by MySQL Powered by PHP Powered by SMF 1.1.19 | SMF © 2013, Simple Machines Valid XHTML 1.0! Valid CSS!
Page created in 0.269 seconds with 18 queries.