Author Topic: Great report on bell housing alignment and a QUESTION  (Read 12539 times)

GaryL

  • Hero Member
  • *****
  • Posts: 538
  • Marilyn and me
    • View Profile
Re: Great report on bell housing alignment and a QUESTION
« Reply #15 on: April 28, 2007, 02:55:19 PM »
I used the hoist for installing the clutch, bellousing etc. I also made a cradle from a 2x6 bottom and 1x6 sides to support from the oil pan rail. The engine can sit on the ground but not on the pan. John Z gaves this recommendation for jacking up an engine in the engine bay. I used it for another purpose. :)
Gary

Lemans Blue X33. DZ, M20, manual steering. Only BU code rear end is original.