Author Topic: 69 bellcrank  (Read 493 times)

69RSZEE28

  • Newbie
  • *
  • Posts: 11
    • View Profile
69 bellcrank
« on: December 16, 2013, 02:11:04 AM »
I am wondering about the bellcrank felts, it appears they are approximately 9/16 I.D and 1.5" O.D. The bellcrank I.D is a lot smaller than 1.5", do you just "stuff" them inside? Also, on the frame side you would have a bushing then ball then bushing then clip then felt? Engine side, you would have bushing then stud then weird looking clip then felt?

JohnZ

  • CRG Member
  • *****
  • Posts: 4277
    • View Profile
Re: 69 bellcrank
« Reply #1 on: December 17, 2013, 05:16:06 PM »
I am wondering about the bellcrank felts, it appears they are approximately 9/16 I.D and 1.5" O.D. The bellcrank I.D is a lot smaller than 1.5", do you just "stuff" them inside? Also, on the frame side you would have a bushing then ball then bushing then clip then felt? Engine side, you would have bushing then stud then weird looking clip then felt?

There's no felt on the engine side - see the exploded illustration in the Assembly Manual, UPC 7, sheet C3. The only felt is on the frame side.
'69 Z/28
Fathom Green
CRG