Author Topic: Floor Boards  (Read 2317 times)

mrdetails

  • Member
  • ***
  • Posts: 164
    • View Profile
Floor Boards
« on: July 27, 2006, 02:51:22 PM »
Hello: Are the floor boards the same for a column shift car (auto) and a floor shift car?
Thanks;
Sam

JohnZ

  • CRG Member
  • *****
  • Posts: 4262
    • View Profile
Re: Floor Boards
« Reply #1 on: July 28, 2006, 02:23:26 PM »
Yes.
'69 Z/28
Fathom Green
CRG

mrdetails

  • Member
  • ***
  • Posts: 164
    • View Profile
Re: Floor Boards
« Reply #2 on: July 28, 2006, 04:21:50 PM »
Were the console weld nuts installed in column shift car floors?
Thks.:
Sam

JohnZ

  • CRG Member
  • *****
  • Posts: 4262
    • View Profile
Re: Floor Boards
« Reply #3 on: July 29, 2006, 02:58:42 PM »
There weren't any weld-nuts in the tunnel for the console attachment; the front bracket has two threaded studs on it that go through holes drilled in the floor with loose nuts on the bottom, and the center and rear attachments use Riv-nuts clinched into holes drilled in the floor. Non-console cars had no holes in the floor - the four console attaching holes were drilled at assembly for D55.
'69 Z/28
Fathom Green
CRG