Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - z28302dz

Pages: [1] 2
1
Restoration / Re: 396, 325hp engine rebuild.
« on: June 23, 2010, 09:24:26 AM »
For a general idea you could pick up a book like, "How to Rebuild Your Big Block Chevy", through Amazon or another book supplier. I think the author was Tim Wilson.  It may help you with a few of your questions, and give you some basics.

2
General Discussion / Re: 69' Z/28 Distributor Date
« on: April 11, 2010, 04:17:42 PM »
I would be glad to.  I also sent a phone number to your message box. 

3
General Discussion / Re: 69' Z/28 Distributor Date
« on: April 07, 2010, 08:26:09 PM »
My car has the same build week as yours, and has an 8M19 in it.

4
My car is also an 02D build, and retains its oringinal trim rings.  Your car would use the clips that go all of the way around.   

5
Originality / Re: Front Calipers
« on: October 07, 2009, 06:41:02 PM »
Does anyone which casting numbers may have been used for the 69' model year?
Thanks again.

6
Originality / Re: Front Calipers
« on: October 06, 2009, 12:13:52 AM »
Thanks Paul.  Anything on date coding?

7
Originality / Front Calipers
« on: September 30, 2009, 11:51:28 PM »
What is the correct part number for Front Calipers on a 69 Z/28, and also what date coding method is used?  Build date is the first week of March.
Thank you.

8
General Discussion / Re: Gear Vendor
« on: June 19, 2009, 11:56:47 PM »
A friend of mine put one in two years ago, and loves it! 

9
Originality / Re: Alternator Bolt
« on: May 13, 2009, 09:52:49 PM »
Thank you very much for the help. I'll check them out.

10
Originality / Alternator Bolt
« on: May 04, 2009, 09:47:02 PM »
Could you please help me with the correct length, and markings on the Alternator Bolt, and Washer (upper) for a 69' 302, 02D build date.  Thank you.

12
General Discussion / Re: '69 Crossram setup
« on: March 17, 2009, 05:03:12 AM »
If it is original, Wayne Guinn at Guinn's Engineering is the person to speak with.

13
Restoration / Re: Mirror Date Code
« on: March 10, 2009, 09:11:20 PM »
Thanks to everyone for the help.  I ordered one through Paragon.

14
Restoration / Re: Mirror Date Code
« on: March 06, 2009, 08:36:39 PM »
So then a February date would be OK in everyone's opinion?

15
Restoration / Mirror Date Code
« on: March 05, 2009, 01:51:40 PM »
What would be the correct outside mirror code for a 69 with an 02 D build.  Thank you.

Pages: [1] 2
anything