Befuddled - Alternator not lining up with other pulleys

[my124677n]

I have raised this issue once befor on the forum, but I can not get my alternator pulley to line up with the water pump & harmonic balancer pulleys on my 1967 small block 327. The latter two are fine, but the alternator pulley is about 1/2 to 3/4 inch behind the other two.  I purchased a new upper bracket and still no luck.  Could the alternator be incorrect for this year block? I have attached two pictures.  Any one out there see anything???

[my124677n]

Here are a few more pictures with the upper bracket in place.

[BlackoutSteve]

It's not uncommon to have to shim the pulley & fan forward with e few washers.
Also, the deep groove alt pulley (I think) has a little more offset that may require no or fewer washers/shims, just in case you were thinking of using one.

[Sauron327]

The stock lower bracket locates the alternator, the upper bracket has nothing to do with it. I had to shim my pulley an 1/8" and I run a Delco. The upper ear belongs behind the upper bracket.

[x77-69z28]

not on 67 it doesnt

[Sauron327]

not on 67 it doesnt

My mistake. I see that now. I have been running a '69 snowflake since '84 and don't run the stock upper.

[my124677n]

I talked to an alternator shop and they are just going to put a double pulley on the alternator.  I will use the outside groove and it should pretty much line up with the other two pulleys.  That should hopefully get rid of the squeak.

[Sauron327]

Something is askew. You should not have to do that if the components are correct.