Sherman’s parts

[jim28607]

Anyone use Sherman's ?
I'm freaking up LOL my 68 rs/ss convertible, and need
Complete floor pan, door shells, fenders and quarters.
Who makes his parts?
Thanks

[x66 714]

Not sure where you're at but there are still lots of good original GM doors & fenders out there. Somebody else will need to discuss other panels with you...Joe

[Stingr69]

Had Sherman parts years ago and the fit was a disaster.  The new rear fender panels had to be sectioned away and spliced to the original quarter because the fit was so bad.  Could not use the whole panel.  They got re-replaced at the next repaint.

A convert that needs everything will test your skills.  My advice - You will need a LOT of bracing to keep the car from collapsing once you start cutting. Save and patch anything original that is still serviceable. 

[jim28607]

Had Sherman parts years ago and the fit was a disaster.  The new rear fender panels had to be sectioned away and spliced to the original quarter because the fit was so bad.  Could not use the whole panel.  They got re-replaced at the next repaint.

A convert that needs everything will test your skills.  My advice - You will need a LOT of bracing to keep the car from collapsing once you start cutting. Save and patch anything original that is still serviceable.

Thank You !! Nuff said on Sherman's , advice taken.