68 Z28 anyone make pre bent stainless lines for the proportioning valve/splitter

[barsteel]

Hello -

Getting ready to install the correct booster, MC, and proportioning valve/splitter brackets on my '68 Z28.

Does anyone make pre-bent stainless lines for between the MC and the proportioning valve and splitter block?

I've searched all of the usual suspects (Ricks, Year One, Classic Industries, Ebay), and I can't find any...

thanks...

Chris

[1968RSZ28]

Chris, check with Inline Tube...

http://www.inlinetube.com/

Paul

[barsteel]

Dug some more and answered my own question - www.camarocentral.com has them...

RSZ28, thanks for the reply...

Chris

[z28z11]

Right Stuff Detailing, Fine Lines if they're still around. Inline Tube has great products, difficult web site to navigate. I've used Camaro Central quite a bit, too -

Regards,
Steve

[68camaroz28]

Hello -

Getting ready to install the correct booster, MC, and proportioning valve/splitter brackets on my '68 Z28.

Does anyone make pre-bent stainless lines for between the MC and the proportioning valve and splitter block?

I've searched all of the usual suspects (Ricks, Year One, Classic Industries, Ebay), and I can't find any...

thanks...

Chris

InLine Tube is one of the best suppliers! Chris, if you are only addressing the MC area and not changing any other lines may I suggest reviewing the thought of stainless lines for two reasons. They can be very difficult to work with and it will look like a mismatch compared to other lines. SS lines can also be a bugger to seal. Many times these brake lines need minor changes to fit properly and the steel are both easier to fit up (they can be a rascal too) and have the correct look.

[Charley]

What he said.....
I would not use stainless.

[Kelley W King]

I agree, SS is a bugger to seal.

[barsteel]

Thanks for the input.  I just ordered the OEM steel lines.

Chris