69 Z28 Carb accel linkage and vacuum hardline?

[JohnZ]

No, because when you place it in the clip and maintain it level the rise is to short. And if you try end remove bends and re-bend it will look re-bent, steel is not good bendable material. I will keep looking.

Thanks

All of the fuel and brake lines are steel, and bend quite nicely if you use a tubing cutter and bender; go to your local auto parts store, get some 3/16" brake tubing, and bend it to suit your application.

[DDZ28]

Sounds like a solution, Thanks John

[zman1969]

Heartbeat City has a repro http://www.heartbeatcitycamaro.com/store/product/13782/Camaro-Vacuum-advance-tube-kit-302-1967-1968-1969/

[bertfam]

EVERYONE has the repop. Just get it from whoever is closest to you.

Ed

[DDZ28]

I have purchased the one from Heartbeat and it does not fit with the Z28 intake. I will make one. Measure the two and post it for info.

[zman1969]

I have purchased the one from Heartbeat and it does not fit with the Z28 intake. I will make one. Measure the two and post it for info.

well that saves me 25$ the only thing i cant make would be the crimps on one end i already have the intake clip so bending the tubing is no big deal thanks ahead DDZ28!

[68camaroz28]

I have purchased the one from Heartbeat and it does not fit with the Z28 intake. I will make one. Measure the two and post it for info.

I have compared the repro to our original and it was the same and fits great. What bracket are you using to hold the steel vac. line?

[DDZ28]

I have purchased the one from Heartbeat and it does not fit with the Z28 intake. I will make one. Measure the two and post it for info.

I have compared the repro to our original and it was the same and fits great. What bracket are you using to hold the steel vac. line?

Do you have a picture?

[DDZ28]

Here are 2 photos of the steel tubes I purchased and 1 that I made to fit.