Big Block heater box cover

[Jody]

Does anyone have photos, or tell me where I can find them, of the correct screws that attach the bracket where the heater hoses goes into the firewall through the cover?

Thank you,

Jody

[bertfam]

Jody, going by your previous posts you have a 69, correct? If so, the bracket screws (number 10 in the drawing below) are P/N 9419321 and you can get them from AMK.

Ed

[Jody]

Yes, I have a 1969 Camaro with a big block.  Thanks for helping.  Someone replaced mine with regular screws.

Jody

[HawkX66]

Here are mine, before and after. Sorry they aren't closer...





I believe these are the same if I remember right:

[william]

Same 9419321 screw is used to fasten the dimmer switch to the floor pan.

[HawkX66]

Same 9419321 screw is used to fasten the dimmer switch to the floor pan.

Are you sure William? They seem awfully short for that. I have one original dimmer switch screw for my 69 and I was looking for the second one.

[bertfam]

Are you sure William? They seem awfully short for that. I have one original dimmer switch screw for my 69 and I was looking for the second one.

Yep. Dave, take a look at your AIM, UPC 12, Sheet B6, item 1 and you'll see it's the same screw.

That screw was used in a TON of places on multiple models and multiple GM divisions, so it's fairly common.

Ed

[HawkX66]

Are you sure William? They seem awfully short for that. I have one original dimmer switch screw for my 69 and I was looking for the second one.

Yep. Dave, take a look at your AIM, UPC 12, Sheet B6, item 1 and you'll see it's the same screw.

That screw was used in a TON of places on multiple models and multiple GM divisions, so it's fairly common.

Ed

Well alrighty then. I'll take a look. Thanks.