cowl plenum

[fireZ]

When a cowl plenum was purchased did the screws to attach the duct to the firewall come in the package also. I have seen different types of screws used. What is correct. thanks as always.

[IZRSSS]

You might be able to find out here...

http://www.yenko.net/ubbthreads/ubbthreads.php?ubb=showflat&Number=433643

[fireZ]

I did see that picture and then I looked at cars at Carlisle and some of them had a small hex screw holding the duct. I cant make out the picture of Jerrys white car to see what is on that car.Thanks again   

[IZRSSS]

Take a look at the pics on this site and their attention to detail. There is a white '67Z under the customer car section w/cowl plenum. This might be the source your looking for...

http://lucas-restorations.com/default.aspx

[fireZ]

I seen that car but when I try and blow the picture up it becomes distorted.

[IZRSSS]

Point...if you take the time to look at their site you will see a section where cars have been meticulously disassembled piece by piece. I am not absolutely certain, but they may have pics of the screws you are looking for.  

Go to their home pg and send them an email. You can access this under "Contact Us". Sometimes these things take a little leg work.

Good luck

[Jerry@CHP]

5/16" indented head screws that are black phosphate in color.  Originals are on my white car.

Jerry

[fireZ]

Thanks Jerry ,you are a great guy to share your knowledge on these cars. Thanks once again Paul Bruce

[tom]

When you are resizing pictures, look for a option, or check box to preserve the aspect ratio. That will keep them from distorting.

[john302]

Do the screws have a built on washer? any head markings? I realize that there were different bolt suppliers . thanks John

[fireZ]

I think they have a built in washer 

[Charley]

So Jerry are you saying the phillips headed screws on my 67 Z are incorrect ?