Rubber repair

[68Zproject]

I have the original rubber boot that goes over the valve on the back of the prop valve on the MC.  It has a small slit in it.  I wondered what I could use to seal it up.  Slicone?  Latex?  How about that stuff in the can that you can make plastic grips for your pliers by dipping them?  Ideas?  Thanks.

[1968RSZ28]

You can buy a reproduction one for less than $4.00...

http://store.heartbeatcity.net/store/product/12345/Brake-proportioning-valve-boot/

Paul

[68Zproject]

Thanks Paul.  I thought I read on here a while back that no one reproduced it.  Looks like they do.

[L78 steve]

The re-pops are terrible .I used some POR-15 on the inside and it sealed it up nicely .Clean with dish soap and water first .