68 Camaro Tunnel 4 speed hole location with console

[Daytona Yellow 69 Z/28]

Hello all,
I am almost ready to paint the floors on my 68 SSRS and I repaired the butchered trans tunnel. I want to cut the correct hole for a factory style shifter and would like to know the correct location if possible. Does anyone have a picture with measurements or a car apart they can get me some exact measurements from? I found a pic for a 69 but isn't the 67 & 68 are different??
Any help with this would be greatly appreciated..
Thanks in advance,
Nick

[1968 Z28]

Try this.......

     http://www.camaros.net/forums/showthread.php?t=67434&highlight=shifter+hole

Post #13 is some photos of the 1968 tunnel with floor shift.

[Daytona Yellow 69 Z/28]

Thank you Jerry.

[big iron]

Nick,
I hope you saved the reinforcement ring that goes on the tunnel, shown in post #13.

Bob

[Daytona Yellow 69 Z/28]

Thanks, I wish but it is long gone

[Sauron327]

If you don't want to make your own ring, they sell it repro.

[Daytona Yellow 69 Z/28]

Thanks, I will look for them. 

[1968 Z28]

Thanks, I will look for them. 

Farther down in that thread I referenced earlier is this link.....http://secure.classichq.com/67-74-FLOOR-SHIFTER-HOLE-REINFORCEMENT-RING--P1388.aspx

[68Zproject]

Jerry, that's spot welded on isn't it?

[1968 Z28]

Yup....mine is.