News:

Classified ads are not allowed on the forum.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - TX-302

#31
A complimentary comment only.... for hard to find CRG items you're usually one of the (experienced) go to guys for CRG thread history. No offense intended.
#32
Hey guys, this may or may not have been covered before but is there any information on the CRG site or from previous threads that define the correct front and rear stripe locations and dimensions for repainting purposes? I'm sure Marty will know.... :-)

Any Vendor recommendations for stripe templates?

Many thanks!


#33
General Discussion / Re: CRG Database
August 08, 2011, 07:36:31 AM
Thanks Kurt
Shall I send the information to your e-mail address?

#34
General Discussion / Re: CRG Database
August 07, 2011, 11:58:31 PM
What sort of information is required to enter a car in the database?
#35
General Discussion / CRG Database
August 07, 2011, 07:26:47 AM
I've notice a Camaro database mentioned in a few CRG discussions. Does CRG maintain a database? If so, how would a Camaro owner go about adding a new entry?
#36
Great to hear all the helpful comments from the CRG guys...... had to chuckle at the age related one, good one Jimmy! You've all convinced me to go solid....and the more noise the better!

http://www.youtube.com/watch?v=PC7NWXwoq9o&feature=feedf_more


Many thanks!
#37
Good point Kelly....getting enough whine now from the M-22!
Thanks for the input....
#38
I'm looking to upgrade the valve train components on my 302 which is currently all stock with the 373 rear gears. As a cam upgrade I'm considering the Competition Cams XE284H (recommended by a local engine builder) and a Pete Jackson timing gear drive. Any camming suggestions or comments on keeping the solid lifter vs hydraulic.... other than authencity would be much appreciated?

Specs:
240 deg duration - 507" lift intake
246 deg duration - 510 lift exhaust

#39
I have to agree with Mark there are many questionable issues on this car.... in addition to that, the POP and paperwork is definitely not 43 years old..!
#40
Was there or is there a Chevy database that kept records of vehicles sold by dealership where VIN's can be cross-referenced to specific dealerships?
#41
Many thanks!
#42
I recently purchased a documented 69Z with the original M-22 trans. Is there any production number data available on the CRG website for total number of 69 camaros equipped with the factory installed M-22? I was told at a car show that production number was approximately 2100.... but would like to confirm.

Thanks
#43
Thanks for all the feedback!
#44
Thanks for the clarification.
#45
Was the reverse lockout installed on all 69 Camaro Muncie Transmissions? Any documention avialble showing illustrations and/or operation explanation?
Thanks!