Messages

Hey Guys, does anyone know anything about the "special" air cleaner on that Camaro???  Very rare I say.  Thanks

Hope everyone here had a joyful Christmas.  Have a Happy New Year too!!!!!!!

Hi guys.  Have a question.  Drive shaft U-Joint has two (2) brackets holding it on drive shaft.   Brackets have numbers 1 thru 4 stamped on top of the bracket.  Does anyone know why??  thanks!

Hey Guys..........Has anyone seen a Camaro big block, with a "torque strap bracket" bolted to the engine???   Are they available??   Any input will be helpful.  Thanks everyone.      Don

I was looking through a Holley carb book recently and found a picture of a 302 chevy small block with three duces sitting on top of engine.  Has anyone seen something like this before???
Thanks

Thank You very much

Carb is on a 1969 Camaro. 396/375 hp.

which carb/car? 4053 or 4346 or? Assuming 69?

Carb is a "4346"............Don

Hi Guys,  I have a question:  Does anyone know what size "jets" a Holley 780 had from the factory?

That is a good question. I am wondering, out loud, does "JUST DASHES" also reskin headrests in spite of the company name?
I have seen some DYI attempts at car shows that look funny, like Hannibal Lector got into interior restoration work (sorry about that).
http://www.justdashes.com/

JIM

Jim, Found a company that does headrest and interiors.  Legendary Auto Interiors @ 1-800-363-8804   Don

Does anyone know of someone who restores "headrests" or seats, that does "quality " work??  Thanks!

Hey guys....Can someone tell me the correct finish the 837 alternator fan blade had?  I believe it was "silver zinc" plating.  Please correct me if I'm wrong.   Don

"68"CamaroZ....This what my mirror looks like.  Thanks for the pics and info.  You've saved me some time re-searching this matter.  Merry X-mas

I have a set of door mirrors for a 1969 Camaro I would like to have restored because they are "Originals".

What is a "set"?  1969 Camaros only had one door mirror, on the driver's side.

My car came with one on passenger door.  This is incorrect??    Don

No, only had drivers side mirror but many were added or dealer installed over the years. Soak in Mineral Spirits for a day and my mirror came out and as Bill stated there are 4 globs of what looks like some type of silicone. Then send your mirrors out to be re-chromed and when returned use an adhesive to place the mirrors back in place. Check the date codes on your glass.

I have the old mirror glass removed now.  I'm just wondering now, will the chrome plating people, re-plate mirrors fully assembled, minus the glass of coarse. I'll have to call around and find out I guess.  Anyone have any further info, please "chime-in"and Merry Christmas

Call RichardFortier. He is the past owner of Paragon Reproductions the Corvette Supplier. He does this type of work, and is restoring the rearview mirror out of one of my 67 Vettes.

10401 Jayne Valley Lane
Fenton, MI 48430
Phone: (810) 750-1472
Fax: (810) 714-4879

Thank you for the contact info....Don.....Merry Christmas!