Messages

Does anyone know what the correct part number  for a late September Camaro drivers side door mirror?

I'm restoring some YH rims and have a concern about the area where the sides of the tire meet the edge's of the steel rim. The area is pitted and I'm not sure if this will seal properly. If rims are pitted can't tire shops use a sealer for just this situation ?

Danny keep your eye's out for 1969 Camaro Z28 shifter linkage. I recently discovered mine isn't correct and I am in the market for some original shifter linkage, thanks.

I recently took out my shifter rods and noticed  my levers were stamped 5615 on both rods. I looked up those numbers and they were installed on 1970-72 Camaro Z28,s .My Z28 is a early September built car. Would it be possible that the 5615 rods and levers were used on my car since it was such a late built car ?

I am looking to replace the trim rings on my 1969 Camaro Z28.  Don't really need originals (I'm just too hard on them) Who sells good reproduction rings?

I've been using spot putty to fill the pitting, I just wondered what other people have tried.

I'm restoring some YH rally rims for my Camaro this winter, after sandblasting I noticed a couple of the rims are pitted from rust . What's the best way to go about repairing those areas that are pitted ?

I have a M21 Muncie Transmission that has the vin. no. 19N642693 and is stamped P9D25B. Would like to find the car it came from.

I see The Eastwood Company offers "rattle cans" that are Satin Black but does not offer paint in small quart cans. Where should I buy my paint products ?

I want to pick up the paint for my ralley rims that I'm going to paint. I'm not sure about the finishes, should the back be a semi gloss Black and the front a semi-gloss Argent Silver ?

The state gave me two of mine over the years, both Z28's, complete right back to the dealer invoices and MSO's. I researched many other cars over the years, and really hate the fact that the State quit providing the old histories.
                                                                                                                                                                                                                                                             I agree, I have a 1969 Z28. I know thru my NCIS report that it was ordered by a dealership in Grand Rapids Mi., and I also know of prior ownership in Wisconsin. I've tried getting info from Wisconsin's DMV but to no avail.  Frustrating

I noticed that my coil wire terminal is bad on my 69 Z28. Where can I find an original wire terminal. It's in the shape of the letter F and has two wires connected to it.

After years of not having a working windshield washer pump (my piston seal was worn out) I finally got it working again ! iI wanted to rebuild my original pump and there is no one that sells a complete rebuild kit for this pump, the only rebuildalbe part that is sold is the tri-port o-ring seal. I ended up buying an Anco pump from RockAuto ($30.88), took apart the pump, removed the new piston and used it in my original pump. My pump works like brand new !

My car was repainted in 1980 but as far as I know the interior was left alone

My 1969 camaro has seat belts most dated 19 A, one 18 A and one dated 28 A. I have an 9 A built car, I know the seat belts are dated early for my car and I don't think they were changed but do you guys think that the car could of be assembled at the factory with these belts?