Topics

Ive been trying to find a new cup seal for my power brake booster for my 1969 Camaro. Does anyone know who sells these?

I'm having brake issues in the 69. I have a super hard brake pedal. I thought it was a power booster problem but this weekend I started to look at the front rubber brake lines. I took off both sides and they are ok, checked the steel lines and they look great, no blockage. I went to bleed the whole system starting at the back and initially I had a small amount of fluid coming through both sides. I went to the front and they bled fine. I thought the porportioning valve on the frame rail was bad so I took off the line before the valve to see if it was plugged and it is fine. Now with that line off I apply the brakes and there is no fluid at all coming from that disconnected line. I haven't checked the other metering valve under the master cylinder. Is there someone that sells rebuild kit for these porportioning valves or is there something else I'm missing?

I'm trying to determine if my rear spoiler is a original spoiler or a reproduction. It has AOS 3949798 for the part number and it has 4 semi circular weep holes. I have read in other threads that original ones have rectangular weep holes.

Does anyone know what this hole with the grommet would be used for. This is a picture of my firewall from my 69 Z28. The area pictured is to the left side of the brake booster, just below the wiper motor.

Does anyone know if fan shrouds are date coded. I need to replace my fan shroud on my 69 Z. I noticed my part number on mine is 3938615 1., I reached out to  Camaro Specialties and they have seen the numbers 1,2, and 3 after 3938615. I would like to know what the numbers mean, any information would be helpful

Is there anyone rebuilding Chevrolet coils? I have a coil off my 69 Z that I would like to have rebuilt.

I just had a piece of my grill break off. It is a vertical slot and it is at the top center right by the hood latch handle. I have the part but I'm not sure how to fix this.

Need opinions on my spark plugs , rich,lean, or just right? It was running rich and I just put 5 gallons of Cam2 in it and seems to be running great. The plugs were fouled before the Cam2. Previous to Cam2 I ran 93 octane gas.

My old reproduction battery is just about done. I have seen some guys used toppers over newer batteries and had good luck . I want to keep the original look to the battery and I want something reliable. Just wondered what tips you guys might have.

I need to replace the rubber seal that goes on the front of the power brake booster (directly behind the master cylinder). Does anyone know where I can find this part?

I have a friend looking at a 67 Camaro. The seller claims it is a real Z28, I'm attaching a picture of the trim tag and one of the car. I did do some decoding of the tag and it looks like it came with a 3-speed floor shifter for M15 or M13 ( 2B ). I not familiar with the 67 trim tag and  I was wondering what you guys think of this tag.

Trying to figure out my power valve size. Wanted to share the pics and get the groups opinion. The first pic is the primary side, second pic is the secondary side

What chemical do you guys use to clean your disabled carb

I want to rebuild my Holley 4053 carburetor. What rebuild kit would you guys recommend.

Ive been trying to figure out why my 302 is running rich and fouling out my plugs. Today I put on a vacuum gauge and it read 20 to 22 and the needle was not steady, it was bouncing. I thought maybe the valve's needed adjusting , did that with no change. I'm not sure if its in the carburetor. Plug wires are new, points were cleaned and reset, distributor cap looks good. Looking for suggestions.

I want to get a new set of date coded spark plug wires for my 69 Camaro.  The car was built the very last week of August . I know 1-Q is correct from Feb to Aug but since my car was built at the end of August would the 3 - Q be correct

Looking to buy 2 new Goodyear Wide Tread GT  tires for my Z , what shops would you guys recommend ?

I know of the location of this.engine , 8N433833 V0509MO

If a 68 Camaro came with a standard interior  would it be possible if the seats would have  white stripes on them? Also how many M22 transmissions did they put in 68 Camaros?

When did Chevrolet switch from stamping the engine vin number on the front pad to stamping it in the rough casting by the oil filter ?

Lately I noticed my brake pedal is really hard when using the brakes, also sometimes I here a groaning noise when pushing on the pedal. The car stalled a few times when stopping. I haven't checked anything out yet but wanted to get some tips on what I should be looking for. 

I'm going to bleed the brakes in my 69 Camaro this weekend and I'm shopping brake bleeder kits. I'm looking for recommendations on a kit. I had a MityVac but it didnt last . I want something better.

I just realized my upper control arm retainer washer and bolt are missing , darn thing just came loose and fell out. Any of the members know where I can locate an original bolt and washer? It's for a 69 Camaro.

Forgot my password over at the Team Camaro site and can't figure out how to reteive it . Does anyone know how to get in touch with the administrator of this site directly ?

I would like to put a fresh set of spark plugs in my 1969 Z28, it has the original 302 in it , what would you guys recommend using? I drive the car around on weekends and don't really need a set of n.o.s. plugs in it.