- Welcome to CRG Discussion Forum.
Welcome to the CRG Discussion Forum!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
General Discussion / New Member just purchased a 1969 X77 D80
October 03, 2014, 01:08:09 PM
Hi All,
This one probably my 12th.
First Z28, but unfortunately it is just a roller.
My original search was for a shell that could be used as another PT Build based upon a Chassisworks Gstreet full frame, TT LSX, 6060, full floater 9 inch.
Very hesitant to cut out the entire floor with this one since it appears to be a correct X77 D80.
Should I attempt a restoration, just stab in something to drive it until the proper drivetrain can be located or sell it as is to someone that can do the work correctly?
The protouring boards are of one opinion, sure you gentlemen (and ladies if any) have another.
This one probably my 12th.
First Z28, but unfortunately it is just a roller.
My original search was for a shell that could be used as another PT Build based upon a Chassisworks Gstreet full frame, TT LSX, 6060, full floater 9 inch.
Very hesitant to cut out the entire floor with this one since it appears to be a correct X77 D80.
Should I attempt a restoration, just stab in something to drive it until the proper drivetrain can be located or sell it as is to someone that can do the work correctly?
The protouring boards are of one opinion, sure you gentlemen (and ladies if any) have another.
Pages1