Messages

Does anyone have a pic of a code 67 without any stripes or vinyl top just the solid color?

  I could measure my opening its a coupe

That would be great I hope to have the lower cowl in by tomorrow night. Thanks ban617

Coupe or convertible?  I currently have a convertible apart that I could measure for you.

Dave

Dave, that would be great! It's a coupe I need to push the A pillar out on the drivers side because the new outer cowl panel is not fitting right. The measurements will help to make sure that the windshield will seal and not leak. Thanks

My 69 project was wrecked on the driver's side at some point in it's life. We installed a new full floor pan, and had to use a port a power to spread the A pillars to get the font of the pan in. So I need to know measurement side to side and upper corner right to lower left,upper left to lower right. Need top of cowl bolt hole for fender side to side also. I mocked up a new lower drivers side cowl panel with the floor out and port a power still pushing A pillars out fit fine. Installed floor as mentioned earlier put new lower cowl in off by an inch or more. Please help thanks, Jeff

I just purchased a 1974 Z28 yes i know it's a second gen but I would like to know the history on this car. I do have two 69 Camaro's that will be checked also.