Messages

Thanks Kurt.

Were these installed at the factory or dealer? Also, are they all the same from year to year?
My 68 SS had no console or gauges, but there was a small round hole in the carpet someone covered from underneath, and when I recently disassembled the car, I found what appears to be the same bracket shown in these kits. Thanks, John.

Denny's Driveshaft. I ordered it online and had it in two days.

Thanks Jerry. I think I just ordered the wrong part then. Almost everything on this car was as-is, but i guess someone must have had the yoke off at some point for the shield to be missing.

This site has been a wealth of information for me, but I have a question that I have not seen addressed. I have a '68 396 car I bought from the second owner in 1982. I am now doing a complete
restoration. When I disassembled the 12 bolt rearend, the pinion yoke did not have the dust shield on it. It also was a u-bolt style yoke. I purchased a new bolt and strap yoke which was referred to as a 1310, and it is close to 3/8" longer from the base of the collar to the bolt surface. Is this the correct item for this rearend? thanks for any help.