Messages

There is also a piece of cardboard like material that is taped on the inside of the dash to cover the speaker grille and there is a rubber plug where the radio antenna harness goes through the body near the right side door. 
Mike

Hi I have this 68 Z28 block 18L320850 VI2IIMO.  The block is standard.
Mike
805-441-5390

I can send pictures by text or email

Hello,
I was employed at Performance Machine in San Luis Obispo California back in the 70's as a crank grinder.   I recall seeing at least two small journal 350 crankshaft that came from 67 Camaro's. Unfortunately I cannot find my book with the forging numbers in it. But I can validate that one of these came from a co-workers 67 SS-350 which I was familiar with and believe was a fairly early production as it did not have the traction bar on the rear end.  This small journal 350  crank hung hung on the rack the entire time I worked there as no one wanted the small journal cranks that would not fit the 4 bolt main blocks.  During my time there and since then I have I have collected many crankshafts.  The one that I find the most interesting is a cast iron 283 crank with a notch in the flange like 302's have and some steel 283's have.  I bet this will start some discussion! I can post photos.  Is there any information on this site about the special 67 SS-350 dimpled connecting rods.