Messages

Just to let everyone know I found a good article that might be helpfull to some people I know it help me here is the web site    www.inlinetube.com/articles/Out%20of%20Proportion.htm

you know thats what i really though it was.  I`ll pick one up and let you know  thanks for the input

















i

My 1969 camaro at one time it was all wheels drum, I replace the from drums with front wheel disk brakes, i had gone with three master cylinders and two power boosters and for some reasons my brake paddle still goes down to the floor giving me minimum brake to stop the car, I had taking the car to the mechanic and they can`t find the problem, went I bleed the brakes is stronger but after a while of driving it goes down again, I don`t notice any brake fluid missing so I must be loosing air from some place can any body help me on this one
                                                                                                                                                                                                 Thanks   
           
                                                                                                                                                                                                   Miguel

My wife and I had decided to take a vacation this June from 22nd to the 28th we are taking our 69 camaro convertible on the road. We are driving from MA. to Williamsburg VA.  it should take us probably 12 to 15 hours. Does anybody knows of any car shows or cruising   places near VA. Beach.   Please let me know thanks.

My car seen to be running to rich on gas, also went I start the car it smell strong on fumes, I also notice that went I punch the gas smokes comes out from the pipes, I believe I need to adjust the needles, can anybody help me with this, I am running a quadrajet made by edelbrock, and is a 600cfm. thanks

On the car that I own and the one before that , I put an HEI distributor that came from a `75 camaro,  on both cars I have to bang the fire wall to make room for the distributor.

Yeah, that is my problem it rubs went I take a corner, I was thinking on going 15x7 on the fronts, I guess I was trying to avoid that answer , maybe i`ll pick a set went I go to the Carlisle car show this April.

My tilt steering came from a 67 or 68 firebird it cost me 50.00 dollars `cause I had to remove it myself, and I did had to change the locking lever I use the one from my original column.

My only input is to make sure  you get and adjustable thermostat , I have a small block  with a four core radiator, and I was having problems with the fan not shutting off , I can see turning on around 205 degrees and it was supposed to shutt off around 160, well it never got to that point and the fan was constantly stayin on, don`t forget you will also going to need a 50amps relay and a breaker another suggestion is to run an led light,  run it from the positive side of the fan wire to the plus side of the led light to ground, so everytime the fun turns on the light will turn on and off went it shutts down, you can monitor this with your water temp. Normally it will turn on around 200 to 210 degrees and should shutt down around 180, Also keep in my some of this fun are very noisy, my sounds like a blower. hope this will help a little.

I really do need some help on this one ,I am running 15X8 wheels front and rear,  my tires are 225,60R15 also front and rear  now my suspension was done a coupple of years ago, my question is everytime I take a fast turn my wheels will rub on the wheel weld, I have to replace my tires, should I keep the same size tires and had the suspension redone again? or should I go to a smaller size tires( which size would you recommend) thanks your input will help my decision.

I noticed that glass packs are making a big come back , I though they were elegal. I had always like the noise that they make but -living  in Ma. they became elegal in the late 80`s. Are this new glass packs different? do they still make the same loud noise or should I just stay with my flowmaster

I hope you can open this

This is my fourth 69 camaro , I had decided to keep this one because is a convertible.

thank you sir

I am replacing my wore out bucket seats on my 69 camaro,I am making the change to a deluxe interior,,or houndtooh interior ,my question is,  are the springs of the bucket seats  compatible with deluxe seat or do I need to get new springs?