Messages

Thx for the photos.  Hopefully, I can make this work.

Dale

Tim -

Any chance you still have the cowl grill off your car?  When I had the bodywork done on my car with the intent of adding factory air, I had a new firewall welded in, but didn't know about the cowl plenum valve and the cut-out needed to install it.

Any chance you - or anyone else reading this - has some accurate measurements for that cut-out on the top of the cowl?  I'm going to have to make that cut myself and would like to get it in the right spot and the right size!  I've seen one set of photos that give a pretty good picture of where it's located, but if possible, would like some real measurements.

Thanks in advance for any info.

Dale