News:

Classified ads are not allowed on the forum.

Main Menu
Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - NickF

#1
General Discussion / Re: Can-am Engine Blocks
November 27, 2017, 02:50:38 AM
Here are a couple of pictures of the block... it hasn't been cleaned, so it is a bit dusty...
#2
General Discussion / Can-am Engine Blocks
November 13, 2017, 07:29:01 PM
Hello there! New to the board, and I have a part that I'm not sure what to do with. I have an engine block that was produced for the Maclaren race team in the late 60's or early 70's. It is a Reynolds aluminum block with a casting number 6272785... kind of a unique looking block and it's standard bore, but after reading a little about them I don't want to possibly render it useless by sleeving it.
Does anybody want this thing, or maybe someone could point me in a direction of someone that would want it?

Thanks in advance,

Nick