Print Page - Rubber repair

Title: Rubber repair
Post by: 68Zproject on April 18, 2008, 12:20:33 AM

I have the original rubber boot that goes over the valve on the back of the prop valve on the MC. It has a small slit in it. I wondered what I could use to seal it up. Slicone? Latex? How about that stuff in the can that you can make plastic grips for your pliers by dipping them? Ideas? Thanks.

Title: Re: Rubber repair
Post by: 1968RSZ28 on April 18, 2008, 01:32:05 PM

You can buy a reproduction one for less than $4.00...

http://store.heartbeatcity.net/store/product/12345/Brake-proportioning-valve-boot/

Paul

Title: Re: Rubber repair
Post by: 68Zproject on April 18, 2008, 11:23:51 PM

Thanks Paul. I thought I read on here a while back that no one reproduced it. Looks like they do.

Title: Re: Rubber repair
Post by: L78 steve on April 24, 2008, 12:08:52 PM

The re-pops are terrible .I used some POR-15 on the inside and it sealed it up nicely .Clean with dish soap and water first .

CRG Discussion Forum

Camaro Research Group Discussion => Maintenance => Topic started by: 68Zproject on April 18, 2008, 12:20:33 AM