Print Page - Recommendations on how to repair carb stud

Title: Recommendations on how to repair carb stud
Post by: Flowjoe on January 07, 2008, 07:41:16 PM

I have a GM high rise Aluminum intake (3972110 - '70 LT-1) it has one bent carb stud...what is the best way to repair or replace this stud?

thanks

Title: Re: Recommendations on how to repair carb stud
Post by: Jerry@CHP on January 08, 2008, 07:42:22 AM

Double nut the stud and remove it. If there are no threads left and the stud is broken, then you'll have to use a pair of vise grips. If it's tight, then heat will have to be used. Good luck.

Jerry

Title: Re: Recommendations on how to repair carb stud
Post by: Flowjoe on January 08, 2008, 09:47:15 AM

Thanks Jerry.

So it is threaded in and not pressed in? I was afraid it was a press in and figured replacement might be as for press in rocker studs.

It has threads left so I should be able to double nut it.

Title: Re: Recommendations on how to repair carb stud
Post by: JohnZ on January 08, 2008, 12:04:04 PM

Quote from: Flowjoe on January 08, 2008, 09:47:15 AM
Thanks Jerry.

So it is threaded in and not pressed in? I was afraid it was a press in and figured replacement might be as for press in rocker studs.

It has threads left so I should be able to double nut it.

Yup, it has ordinary 5/16"-18 threads on the manifold end of the studs.

CRG Discussion Forum

Camaro Research Group Discussion => General Discussion => Topic started by: Flowjoe on January 07, 2008, 07:41:16 PM